Swift FX Nano

Small in size, big on comfort

An open, streamlined design of nasal pillows with the comfort of a nasal mask.

Quick-fitting, minimal design

Two-point headgear with no need for rigid frames or forehead support.
Stylish headgear and fit range specifically for women in the Nano for Her.

Complete comfort

The modified dual-wall nasal cushion provides a supportive seal with greater flexibility.
Whisper-quiet venting gently distributes air away from the patient and bed partner.

Freedom of movement

The ball-joint elbow rotates 360 degrees to accommodate various sleeping positions.
Spring-flex tubing and the dual swivel reduce pull on the mask.
Cushion tab hinges add flexibility to compensate for additional movement.

Fitting tips

If air is leaking, check for leak and adjust the backstrap.
Do not overtighten the headgear straps.

Ensure that the bottom of the cushion opening aligns with the bottom of your nose, then place the mask over your nose.
Pull the headgear over your head so it sits midway between the ears and eyes.

Adjust the top strap for positioning, one notch at a time, until the mask is comfortably over your nose. Do not overtighten.

TIP: If the cushion is putting pressure on the bottom of your nose, loosen the top strap.

The backstrap should sit just above the ears at the back of the head.
Adjust both fasteners on the fabric backstrap at the same time.
Ensure that the backstrap sits over your hair.

Ensure that the mask is comfortably sealed.

TIP: When adjusting for leak, adjust the backstrap.

Adjust the nasal cushion until it sits comfortably on your nose.
Connect the free end of the short tube assembly to the air tubing of your device, then turn it on.

If air is leaking, check for leak and adjust the backstrap.
Your mask is now ready to use.

TIP: For optimal performance, wear the tube in the down position.

Optional Soft Wraps

Wrap each of the soft wraps around either side of the headgear, folding the top fastener over the lower one.
The soft wraps should be positioned on your cheeks, with the fasteners on the outside.

The soft wraps should be positioned on your cheeks, with the fasteners on the outside.
Note: For additional information, refer to the Swift FX Nano Nasal Mask User Guide.

Complete mask system
Swift FX Nano (Standard)	62200
Includes Standard cushion, Swift FX Nano headgear assembly, plus gray backstrap, soft wraps and frame assembly
Swift FX Nano (Wide)	62251
Includes Wide cushion, Swift FX Nano headgear assembly, plus gray backstrap, soft wraps and frame assembly)
Headgear
Headgear Assembly (Gray)	62238
Includes headgear, backstrap and soft wraps
Frame system
Standard	62220
Wide	62271
Small	62221
Cushion
Standard	62230
Wide	62281
Small	62231