Ultra Mirage Full Face

The Mirage dual-wall cushion reduces pressure on the nasal bridge and optimizes seal and comfort.
The forehead support provides seal and stability with a choice of four clearly numbered positions.

While the device is turned on, pull the mask away from the face to reinflate the cushion; then adjust the headgear straps.
Do not overtighten the headgear straps.

Place the headgear on the face and pull it over your head.
Make sure the upper straps pass across the forehead and lower the straps below your ears.
Reattach the headgear clip to the mask frame.

Gently tighten the upper and lower straps. The forehead support pads should lightly touch the forehead.
Do not overtighten the straps.

Connect one end of the air tubing to the mask swivel and the other end to the flow generator.
Turn the flow generator on.
If air leaks around the cushion, you may need to change the position of the forehead support tab.

Loosen the upper headgear straps and move the forehead support tab downwards to the next position (position 3).
Gently tighten the upper headgear straps.

Test all four positions of the forehead support tab and adjust the headgear straps until you achieve a secure and comfortable fit.

Complete mask system
Small Standard	60600
Small Shallow	60601
Medium Standard	60602
Medium Shallow	60603
Large Standard	60604
Large Shallow	60605
Frame system
Mask without headgear, includes headgear clips
Small Standard	60620
Small Shallow	60621
Medium Standard	60622
Medium Shallow	60623
Large Standard	60624
Large Shallow	60625
Frame assembly
Headgear clips included; headgear and cushion not included.
Small	60666
Medium	60667
Large	60668
Headgear assembly
Clips not included
Small	16118
Medium	60674
Large	16119
Elbow assembly
Includes elbow retainer, valve frame, membrane, elbow, swivel clip and swivel	16613

Table of contents