Ultra Mirage II

The Mirage™ dual-wall cushion reduces pressure on the nasal bridge and optimizes seal and comfort.
The forehead support provides seal and stability with a choice of four clearly numbered positions.

Headgear clips allow for quick attachment and detachment of the headgear — no further adjustments are required after initial fitting.

The vent design minimizes airflow intensity and noise.
Specially designed to direct air away from the user and bed partner, and to provide optimum CO₂ washout.

Disconnect one headgear clip.
Ensure that the forehead support tab is in position 1. Place the mask on your face and pull the headgear over your head. Make sure upper straps pass across the forehead and lower straps below the ears.
Reattach the headgear clip to the mask frame.

Gently tighten the upper headgear straps. The forehead support pads should lightly touch the forehead.
Do not overtighten the straps.

Connect one end of the air tubing to the mask swivel and the other end to the flow generator.
Turn the flow generator on.
If air leaks around the cushion, you may need to make some adjustments. In this case, proceed to step 5.

Loosen the upper headgear straps and move the forehead support tab to another position (eg, position 2).
Gently tighten the upper headgear straps.

Test all four positions of the forehead support tab and adjust the headgear straps until you achieve a secure and comfortable fit.

Complete mask system
Standard	16548
Large	16549
Shallow	16550
Shallow Wide	16577
Frame system
Mask without headgear, includes headgear clips
Standard	16726
Large	16728
Shallow	16727
Shallow Wide	16736
Frame assembly
Includes headgear clips. Headgear and cushion not included.
Standard	16594
Headgear
Clips not included
Small	16118
Medium	16117
Large	16119
Elbow assembly
Includes elbow clip, vent cover, elbow and swivel	16566

Table of contents